Forget-Me-Not Crochet Pattern
Create a delicate five-flower spray with lilac petals, yellow bead centers, and fine wired stems. This easy forget-me-not crochet pattern uses one short round for each flower and includes a clear assembly guide.
Start step reader
Before you start
The forget-me-not crochet pattern is worked from the center outward. Each flower has five identical petals. A yellow pearl is wired through the center after crocheting, then five finished flowers are twisted into one balanced spray.

Materials and abbreviations
- Lilac cotton crochet thread, size 8
- 1.90 mm crochet hook (US B)
- 0.6 mm craft wire
- Five yellow pearls or beads
- Yarn needle and scissors
- Small pliers for shaping the wire
| Abbreviation | US meaning |
|---|---|
| MR | magic ring |
| ch | chain |
| sl st | slip stitch |
| sc | single crochet |
| dc3tog | three double crochets closed together |
If your hook label differs, compare its metric size with the Craft Yarn Council hook guide.
How to make the petal cluster
For dc3tog, yarn over and insert the hook into the magic ring. Yarn over, pull up a loop, yarn over, and draw through two loops. Repeat that partial double crochet two more times into the ring. Yarn over once more and draw through all four loops on the hook.
The chain-3 spaces form the two sides of each petal. Keep all ten chain sections similar in height so the five petals sit evenly around the center.
Forget-me-not crochet flower: Round 1
| Stage | Instructions | Check |
|---|---|---|
| Center | Make a magic ring with lilac thread. Leave a tail long enough to tighten and secure the center. | Ring remains adjustable |
| Petal repeat | Work 1 sc, chain 3, dc3tog, chain 3 into the ring. | One complete petal |
| Complete the flower | Repeat the petal sequence four more times for five petals total. Join with a slip stitch. | 5 petals |
| Close | Pull the loose starting tail to tighten the center. Fasten off and secure both ends. | Center is firm and flat |
Make five identical flowers. Before wiring, compare them side by side and adjust the petals so each corolla has a similar diameter.
Wire and assemble the five-flower spray
- Cut a suitable length of 0.6 mm wire for each flower.
- Insert one wire through a yellow pearl and position the pearl at the center of a crocheted flower.
- Pass the two wire ends through the flower center without splitting the stitches.
- Twist the wire ends together directly below the flower to secure the bead and corolla.
- Repeat for all five flowers.
- Arrange the flowers at slightly different heights, then twist their stems together into one natural-looking spray.

1. Make the magic ring
Form an adjustable magic ring with lilac cotton thread.
Final quality checks
- Every flower has exactly five petals.
- All five centers are tightly closed.
- The chain-3 sides are even.
- The bead sits centrally on each flower.
- Wire does not split or distort stitches.
- Each individual stem is tightly twisted.
- The five flowers sit at varied heights.
- Sharp wire ends are covered or turned in.
Helpful shaping tips
If a flower curls too strongly, gently block it before adding the bead. Pin the five petals into shape on a foam mat, mist lightly, and allow the thread to dry completely. When assembling, place three flowers slightly higher and two slightly lower for a natural branch silhouette.
You can change the flower color while keeping the same construction, but use beads of similar weight so the wired stems balance consistently.

Leave a Reply